Worth chasing ?
- Thread starter Goldfreak
- Start date
Help Support Prospecting Australia:
Moneybox
Philip & Sandra Box
That's an excellent result from a half a bucket of gravel. Now you just have to work out a way of processing a larger quantity. I wouldn't get that much from most of my dirt but if I can process several tonnes then it starts to pay well.
I think its stuff the old timers may have spilt or broke off while heaping ore from anouther location. Can't locate any nearby reef or source but have found amalgam nearby which contained gold and various old machine parts. There would be a few ton of it laying around spread over a couple of acres but all in small bits but that's fine. I have a little hammer mill that can only take gravel size anyway.
Last edited:
Judging by that first good-looking panful from such a small sample amount, you could be on to a nice little earner there at today's gold price! Go for it, I reckon and the best of luck to you.
You want to borrow my AlgoForce to sniff around with?
I might go back for more. Currently processing the second half of bucket.Judging by that first good-looking panful from such a small sample amount, you could be on to a nice little earner there at today's gold price! Go for it, I reckon and the best of luck to you.
Good result if that is a representative sample.
The issue may boil down as to how easily you can scoop it all up.
If it is just surface material, I have seen people here in Vic dragging heavy wooden planks behind an ordinary car to imitate mechanical "scraping" (a long time ago now). The winrows left would at least provide some concentration of the scrapings.
The side benefit could be that it might also improve detectability of the area.
Just some thoughts.
PS brought back memories of me and my brother dragging a heavy plank over his newly rotary hoed block to level out the area he wanted for a lawn. We felt like draft horses pulling a plough (again that was a long long time ago).
The issue may boil down as to how easily you can scoop it all up.
If it is just surface material, I have seen people here in Vic dragging heavy wooden planks behind an ordinary car to imitate mechanical "scraping" (a long time ago now). The winrows left would at least provide some concentration of the scrapings.
The side benefit could be that it might also improve detectability of the area.
Just some thoughts.
PS brought back memories of me and my brother dragging a heavy plank over his newly rotary hoed block to level out the area he wanted for a lawn. We felt like draft horses pulling a plough (again that was a long long time ago).
Last edited:
That's okay. Have been over it with the monster. But for this super fine stuff scattered on the surface recognising the type of stone and a little hammer mill seems to be the go.
Last edited:
A rake might work well. Bit hard to access the location with a vehicle. Have finished crushing last of the sample bucket but ran out of dy light. Will pan it out tomorrow after work and post results.
Moneybox
Philip & Sandra Box
Probably best to work without the vehicle anyway. The prospecting rules in most places prohibit the use of motorised equipment.
We had a gentle slope that produced a lot of small gold from limestone, I think some call it calcrete. Most nuggets were between 0.1g and 0.6g so Mrs M worked it with the SDC while I worked another area that had bigger gold up to 19g with the GPX4500. After she'd finished getting most of the gold we hooked up a big heavy steel cart tyre to the back of the bus and dragged it over the patch breaking down the uneven limestone surface. After dragging the entire area we never got another nugget. We destroyed it
