Phantom
Eric Walker
GoldTarget,
All suggestions welcome.
I like your idea and will start to design some form of header box maybe with a few levels of mesh, I'm thinking:
1. Heavy rubber lid to contain the energy of the pump input and force it down through the sheets.
1. 3/8" perforated sheet, Material caught here would wash onto the self classifying tray or if oversize could be wiped off.
2. 1/4" mesh. Material caught here would wash onto the top self classifying tray. The material, sub 1/4" would fall directly into the bottom intake of the sluice (breadboard ). and would, therefore, go through the full natural classifying.
All suggestions welcome.
My main concern would be to stop clogging, maybe have mesh on angle, slopping towards classifier tray, this way the flowing water would push through mesh helping move it.
P.S I know I should build a HighBanker but I just want t get this working.
Regards,
Phantom
All suggestions welcome.
I like your idea and will start to design some form of header box maybe with a few levels of mesh, I'm thinking:
1. Heavy rubber lid to contain the energy of the pump input and force it down through the sheets.
1. 3/8" perforated sheet, Material caught here would wash onto the self classifying tray or if oversize could be wiped off.
2. 1/4" mesh. Material caught here would wash onto the top self classifying tray. The material, sub 1/4" would fall directly into the bottom intake of the sluice (breadboard ). and would, therefore, go through the full natural classifying.
All suggestions welcome.
My main concern would be to stop clogging, maybe have mesh on angle, slopping towards classifier tray, this way the flowing water would push through mesh helping move it.
P.S I know I should build a HighBanker but I just want t get this working.
Regards,
Phantom