I will need to give this a try.
Cheers
Cheers
GPX Specific Ground Balance
- Thread starter lost a bit
- Start date
Help Support Prospecting Australia:
https://www.detectorprospector.com/...ic-ground-balance/?tab=comments#comment-72591
I asked the question over on DP for you. Phrunt found a Minelab Treasure Talk thing about it. It's a bit old but should still be relevant. Rather than just linking the tech talk I have linked the page on DP forum as I think that's the right thing to do.
Good luck :Y:
I asked the question over on DP for you. Phrunt found a Minelab Treasure Talk thing about it. It's a bit old but should still be relevant. Rather than just linking the tech talk I have linked the page on DP forum as I think that's the right thing to do.
Good luck :Y:
Well done Northeast. Thanks for posting elsewhere and getting a response. Thank phrunt for me.
That link was very informative and answered the question about using the quick track button after doing the first Specific Ground Balance ....... I quote the Minelab Treasure Talk .......
"After this first ground balance then you can subsequently use the green Quick-Trak button in the normal way".
Will have to give Specific Ground Balance a go in highly mineralised ground in the Vic GT.
Sounds promising.
Thanks again. Cheers
That link was very informative and answered the question about using the quick track button after doing the first Specific Ground Balance ....... I quote the Minelab Treasure Talk .......
"After this first ground balance then you can subsequently use the green Quick-Trak button in the normal way".
Will have to give Specific Ground Balance a go in highly mineralised ground in the Vic GT.
Sounds promising.
Thanks again. Cheers
No troubles - will do. A problem shared is a problem halved 
:Y:
So, is this what you should always do on new ground; or only on new noisy ground?
As per the instructions you only need to try Specific if you can't achieve good ground balance with General. I've never used Specific and have always put up with poor ground balance at times. So I will certainly give Specific a go next time I can't get good ground balance with General. Another point of learning and is another example of what makes this forum great ...... people helping others.
The instruction manual says for highly magnetic iron rich ground areas. Page 54.
As you use the machine you have to go back and read the instruction book again; and again; as it all starts to fall into place. Little things you did not understand at the begining you can see how it is relevant. :Y:
I did not realise you can set up the machine for 3-4 diferant settings, change the switch and your machine is set to go. General; Deep; Patch; etc,. It saves the setings, you don't have to reset every setting on the detector each change, just your Gain & Stabiliser.
I did not realise you can set up the machine for 3-4 diferant settings, change the switch and your machine is set to go. General; Deep; Patch; etc,. It saves the setings, you don't have to reset every setting on the detector each change, just your Gain & Stabiliser.
Theres a lot of ground in the Vic GT where the ground is highly magnetic ....... you put your pick end magnet to the ground and you get an instant clump of ironstone attached to it. Specific will certainly be worth a try in these areas. In the past in areas like this Ive turned down Rx and Stabilizer, switched to Sensitive Smooth and even tried Quiet Audio and then still walked away.Heatho said:
- Joined
- Jul 25, 2018
- Messages
- 34
- Reaction score
- 58
Hi folks (newbie here)
I know my way around these detectors pretty well. I have detected WA in all the usual places south of Peak Hill and a wee bit east of Kal etc.
Its been a rare day that specific has been called for but i am sure glad its there. If your using it then ground balance (green button) fairly regularly.
I mostly detect early morning and evening and run my 5000 in fixed, not tracking with General ground balance
I know my way around these detectors pretty well. I have detected WA in all the usual places south of Peak Hill and a wee bit east of Kal etc.
Its been a rare day that specific has been called for but i am sure glad its there. If your using it then ground balance (green button) fairly regularly.
I mostly detect early morning and evening and run my 5000 in fixed, not tracking with General ground balance
