DIY Dolly Pot

[silver]

Probably used a couple of jumper leads and some rusty fencing wire(it looks good)

 

[Ag Man]

I use a holesaw in a bench press without the pilot, to cut a round circle a couple of mm deep into the base, slightly finish the tube on the end, this allows the pipe nest into the plate and also eliminates any creeping of the tube during welding, eliminating any gaps or holes.

For hard applications I also use a plunger that has spikes, made from hard facing the end of the plunger, for the more resistant samples, one pot, two plungers.

But I will say very nice job indeed, very neat, and god, love that weld, 240v, or 415 mig?

Sorry about the decade delay
Stick welder mate. 240v CIG Easy Welder I think it was called.
Not stainless pipe. Just cleaned up mild steel with wire wheel on bench grinder.
Never paint the insides of a dolly pot or you’ll end up with paint flakes & dust in your cons.
Cheers

 

[Mackka]

Welcome back fella.

 

[Ag Man]

Welcome back fella.

Cheers cob
Never really left .
Just pop in less frequently since the site was sold to overseas.
Does Harry still own it or who now?