Highbanker expanded mesh

[lancebarker]

Would anyone know where I can get expanded mesh for a highbanker in either Victoria or Canberra? Thanks in advance, Lance

 

[jamie]

if you have a scrap metal place near you it may be worth a try there mate, generally you can get an off cut at a good price or engineering shops that do HD trailers or walkway manufactures, if they are like my local engineering guy dont ask for scrap piece ask for an off cut cause according to my guy 'no scrap here mate, just good off cuts' lol

 

[DirtyBob]

Hi Lancebarker

Not sure if you're from Vic or Canberra, but MetalMart at Fyshwick (Canberra) has a scrap metal facility out the back and usually have the vertical catwalk mesh cheap.

I still haven't been able to locate the sloped mesh as yet.

DirtyBob

 

[jamie]

i have a little bit of the sloped expanded but it is steel if you are in the wollongong area at all it may help you out

 

[Colour Blind]

i have a little bit of the sloped expanded but it is steel if you are in the wollongong area at all it may help you out

Hi Jamie,
Can I ask where you got the sloped mesh from, I've been looking for a while with no luck, I'm from the Illawarra too, if you could point me in the right direction it would be greatly appreciated.
I have sourced the vertical mesh, so just running that at the moment.

 

[lancebarker]

Thanks all for your replies. Really appreciate the guidance/direction you have given me.
Regards Lance

 

[limpalot]

I go to Surdex steel, ask them for the size you want and a price. Tell them I Only need a bit who do you sell that to; go to that fabricator and ask them if they have a piece. You know the price of a sheet, and can bargan for the piece you want.
Cheers LL

 

[jamie]

i have a little bit of the sloped expanded but it is steel if you are in the wollongong area at all it may help you out

Hi Jamie,
Can I ask where you got the sloped mesh from, I've been looking for a while with no luck, I'm from the Illawarra too, if you could point me in the right direction it would be greatly appreciated.
I have sourced the vertical mesh, so just running that at the moment.

Hi mate sorry only just seen your reply, sending your a pm