Search results

looks awesome, I though my nox 800 would be my all the time machine but if this is waterproof and had the 2d target id and GPS mapping that the CTX3030 has im keens mustard! half of my mates still use the CTX but theyre old batteries have been replaced a few times and the recovery is so slow...

definitely need a fuse mate, its rated and written on most bilge pumps. its more to do with low quality or non regulated batteries and batteries on the way out, a battery thats close to death might discharge at 14 volts causing a short which produces heat and will melt your good pump, an inline...

looks like an awesome day out mate good to see the legs are serving you well

tell ya what things are pretty bleak for alot of people right now, i was in sofala at the NAPFA AGM on the weekend had to leave early got the call from the mrs water was coming into the house (were in redcliffe) i came accross the gap through warwick and got pinned just before the kalbar turnoff...

nice looking chunky cornflakes there jethro

he made it himself mate, pretty easy stuff little bit of bbq grill with a bent c section and two holes to mount in the existing arms bolt

nice chunks there 20

looks like it was a great trip jamie

well done mate

no worries mate

thats awesome i didn't know they made them that small,

i've had a few guys over the years come in and buy a second 1100 gph to run a small highbanker with the same concept, makes sense cheaper light on amp draw etc two have come back and bought a bigger pump due to being fiddly. I've seen some of keenes mini bankers do this also split the load over...

my advice mate, most of the testing we do for dream mat tech we use tungsten its SG is almost exactly that of gold, it behaves a little different but when you buy a few ounce jar you get the full range down to 200 micron in ground weight. they are used to weight all maner of gold gear very...

simple answer is yes, there's alot of low grade sulphide rich ore out there that's just not practical to recover for the average prospector. i know of a mine in vic where the ore is less than 0.1 g/t the old timers processed some by paddock leaching before roast and cyanide but the yields were...

you'll find most layflat hose is 38mm rather than 40mm so you'll need to use some grease of some sort, i use bearing grease on mine but anything will do, also you should use a rubber mallet to knock the camlock in, short sharp knocks

there's always water somewhere at slaty, further up the system you go you'll find deeper bedrock pools, also alot of the side roads have dams, theres at least 5 i know of that have water all year round.

on the money

i grind and harden mine each time with a little oil bath each year, definitely helps cutting through tree roots etc easier on the back

there's some crazy ideas lets start with bending 3mm aluminum on an diy press brake (with any ease very difficult) 9 tonne would be the minimum rated load on 3mm. id stick with under 2mm I do encourage people to make thier own equipment though this thread is specifically about a gold rat mini 6...

4wd 100%