XLOOX's latest activity

The mods were done by Detectronics at Dunnolly, if you contact them they will explain what they do and how it will work.

Apparently the man at dunolly does good jobs on mods, i would go to him but unfortunately as axpart pensioner cannot afford to get it...

When I went to WA i used the 6000 for scouting out patches as its very light and can cover ground quickly. It can find little pieces...

What were the mods to your mates 4500 and who did them?

Yes, I agree with that math and also if you were to squash 17"x13" elliptical coil into a round it should create a 15" diameter round...

Hey Wow shaft plus coil 1023g? that would make it slightly over 900g coil. Hmm it is back in the race...I will have to borrow one...

Thanks. 1100g is more than I am willing to swing these days and having tasted the freedom of wires, bungees, harness etc that the 6k...

The attached link on Dectector Prospector shows current GPX-6000 coil sizes, weights, and areas. GPX 6000 Coil Chart

Very true 17 +13 =30/2 =15. I havent used the ML 17x 13 but I have seen 2 different weights quoted - 800g and 1106g. If it was 800g...

Yes the 6000 is an "easier" machine compared to the 7000, and it is a joy to use! Ready from the start, light to swing around, very...

I use the ML 11" wherever I can as it goes pretty deep, sees damn small and has a fair sized hotspot. The large hotspot is nice for...

My advice is to widen the hole you dug as it could be in the side wall. Also a crowbar is handy aswell. Usually rusty objects are easier...

Something the size of a dog bowl can be detected at nearly 5 feet, so a small rusty gold pan or similar may be causing the response. If...

If you're serious about making skid plates then I suggest you setup for vacuum forming. You need an oven with sufficient size to house...

That specific one may work fine for powering starlink but its advertised capacity is a crock as 200 000mAhr is 200 Ahr. A genuine...