SDC 2300 Speaker and Armrest Mod.

Redfin · Sep 2, 2015

I have had a few requests on how to, so here goes.

Get some appropriately colored HDPE [cutting board] and cut to suit.

Heat up and bend to shape

drill some retaining holes in speaker clip

make sure the angle of the dangle is ok

Attach speaker to HDPE with self tappers, I used some rubber washers as isolastic suspension.

Apply some sticky velcro

and first stage done, I used a cable tie for extra strength

Redfin · Sep 2, 2015

Now for the cuff.
Some 90mm PVC pipe

Cut to size and shape

Once again apply velcro

I used a standard Minelab cuff cover to finish off.

Very little cost, great with the speaker actually facing you.

Keano · Sep 3, 2015

Thanks mate, greatly appreciated. How does it go on windy days? or do you just revert back to headphones?

Redfin · Sep 3, 2015

No problems in the wind for me

PhaseTech · Sep 3, 2015

Run those arm straps through the slots in the neoprene cover, and it'll be bliss

Mackka · Sep 4, 2015

Hey Redfin are you getting in early for Christmas hehehe. (Christmas card and tinsel)
Cheers
Mackka

Redfin · Sep 6, 2015

No Mackka, those pics were taken last Chrissy.

Join the conversation!